The Inexplicable Mystery In to Pet Fence Repair Broken Wire Found
It’s important to note that the sleeves should be positioned in such a way that they’re evenly distributed along the length of the splice. Next, strip the insulation from the ends of the wire using wire strippers. Ensure that the exposed copper wire is clean and free from any debris or coatings that could hinder the soldering process.
This can be difficult if your electric dog fence is fully buried. If your wire is old and degrading, it may be a good step to take. You can use a new wire and thread it through PVC pipes to keep it safe. Since most wires are either on the surface or buried less than three inches, they can be cut easily.
First of all, unplug the transmitter from the control box and change its setting from FM to AM. By doing so, your transmitter will begin sending the low-frequency radio signals to the invisible fences, instead of a strong single. Follow the path of the boundary wire around the perimeter of your lawn, listening carefully for the AM radio interference signal. When you move away from the wire, the signal will fade or stop. This will help you to stay directly over where the perimeter wire is. Ensure the wiring is not broken and does not have any debris like trees, grass, or leaves touching it.
If you leave your fence plugged in, the bad splices and nicks corrode slowly. Thus, a fence left energized, albeit in a state of high resistance will generally not trigger a wire break alert for much longer than one left unplugged. If the invisible fences are equipped with fresh batteries, check the loop light.
Recently a big storm toppled some trees and cracked the power pole out behind our house. The power company came an replaced it yesterday but in the process broke the wire to the dog fence with their tracked utility crane. So, whenever the wire breaks, it stops transmitting the radio signal from transmitter to receiver properly. Resultantly, when your dog comes close to the boundary region, his receiver doesn’t induce any correction.
The ridges must be facing up; the collar will slip if it is not properly threaded. The slide buckle prevents the collar from becoming loose around your pet’s neck. The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains in the Static Correction Zone if the collar is set at level 2 or above.
Imagine absurd your front patio look if it has countless muddy paw prints. Hopefully you don’t have to worry about boundary wire problems too often when using your pet fence repair broken wire robot lawn mower, but if you do, I hope this information has been useful. Let me know in the comments section about your experiences with damaged perimeter wire.