Reasons Why Invisible Fence Break Locator Gets Bad Reviews
Following are the three different methods for finding the break in your dog fence. Carefully walk along the entire perimeter of the fence, checking for consistent signals from the collar receiver. If you notice any weak spots or areas where the signal is not being detected, it may suggest additional breaks or interference in those specific locations. In some cases, breaks may be more challenging to locate, especially if the wire is extensively damaged or if there are multiple breaks. You can fix a broken invisible dog fence by joining the wires yourself or calling a professional to help you.
These can fail internally over the years, even with new batteries installed. Contact the manufacturer and see if they offer a free unit evaluation. Some companies will replace older models if found to be malfunctioning. Getting a professional diagnosis is the safest invisible fence break locator way to rule out a defective transmitter as the root cause. If you’ve just heard your device beep for the first time since you began your search, wait for a few moments in that spot. If the beeping continues, walk a few steps in every direction, starting with North.
Simply strip off half an inch of insulation on each side of the wire break and use a waterproof wire nut or a splice capsule to rejoin the two ends of the wire together. Last but not least, a malfunctioning transmitter may be the cause. The transmitter may have been damaged by an electrical surge or by lightning. The only way to fix this problem is to purchase another transmitter. When purchasing a new transmitter, consider buying battery backup and surge protection. You should also scope out areas with heavy foot traffic, like pathways, driveways, and sidewalks.
Walk towards the invisible fence perimeter from the starting point. You should locate the underground wire a few feet away from the collar beep. So, whenever the wire breaks, it stops transmitting the radio signal from transmitter to receiver properly. Resultantly, when your dog comes close to the boundary region, his receiver doesn’t induce any correction. One using the short looping method with an extra wire, one using a wire locator with the short looping method, and the final using an AM radio. This test will confirm that the dog fence transmitter is sending a radio signal along the short loop test wire and that the receiver collar is accurately receiving the radio signal.
Run a piece of extra wire over an underground section of wire. Connect the above-ground wire to both ends of the underground wire to create a bypass. Our branch is an authorized, full-service dealership of genuine Invisible Fence® Brand products and services.
Also, remember to pay extra attention to areas, such as the pathway, driveway, or sidewalk, where there is heavy foot traffic. At We Love Doodles, we’re a team of writers, veterinarians, and puppy trainers that love dogs. Our team of qualified experts researches and provides reliable information on a wide range of dog topics.
The beeping will stop using a wire locator when it crosses the break. In addition, it’s possible to detect radio waves by using a homemade radio detector, which will cut out some of the static. If you’re installing an invisible fence, use a wire locator compatible with the brand you selected. Or maybe you can make a wire locator out of an AM radio tuned to the same frequency as your fence.